Skip to main content

Wish I had $17k....

This 1965 R60/2 and Steib sidecar sold on eBay today for $17,000 AUD. What a stunning outfit. Looks like it could have been ridden away when it was paid for. Hope the new owner uses it on the road too and doesn't leave it sitting in a garage all the time.

Here is the sellers blurb about it...

R60/2 (r60 stroke 2) with Steib S500 sidecar currently registered.

A rare opportunity to purchase or invest in one with the lot.

The bike is a 1965 R60/2 ( matching frame and engine numbers 627688 ) 53,300 miles with a Steib S 500 (VIN 37827) that comes with a lot of desirable features of that period such as the following

6 gallon tank with top toolbox and roundells that fit behind the tank badge
Factory 12 volt electrics.
Bar end blinkers.
Full stainless steel exhaust system.
Large capacity Bowman sump.
Finned exhaust nuts.
Rare sidecar gearbox, low 1st and 2nd with normal 3rd and 4th for highway speeds.
Pagusa solo seat with Denfield breadloaf seat.
New shocks front and rear with sidecar springs.
Full craven pannier system.
Pump.
Heavy duty sidecar spokes all round.
Steib S500 sidecar with factory ATE hydraulic braking system. 19inch braked wheel.

Comes with factory workshop manual (bit tattered but usable) and photocopy of owners handbook.

Also comes with Bike and sidecar trailer, Heavy duty made from a boat trailer, PLEASE NOTE IT HAS NOT BEEN REGISTERED AND IS UP TO PURCHASER TO DO SO.

There are receipts that come with the bike showing work history totaling $2000 the motor has been rebuilt starts first kick and runs like a Swiss watch.

There are some dents in the sidecar on top and on guard, there is a small aluminum strip missing of the bottom of the sidecar, there is some surface rust on the frame where the original paint is now thin. The tank has some very small dents, this is all part of a 52 year patina.

Will sell worldwide will assist by delivering to nearest shipping port, costs to be paid by purchaser.

With bike comes a rare HEINRECH 8 gallon petrol tank with lockable aluminum lid.
The tank has had some work done to it ,The tank will need to be sealed, and painted.





Comments

  1. Hi,there!
    It's first time to visit your blog.
    I am from Japan.
    Catch you later.

    ReplyDelete

Post a Comment

Popular posts from this blog

Tuning 40mm BING CV carburetors for BMW motorcycles by ear.

Steve Doyle has put together this great and simple guide to tuning your Bing carbs. No need for expensive tuning equipment. So over to Steve...... Any feed back on this How To please email me and I will pass it onto Steve. There are 3 common methods to syncing the carbs. They will all work 1. Shorting the plugs. http://bmwmotorcycletech.info/synchcarbs.htm and http://www.airheads.org/content/view/216/98/ 2. Using a manometer of some sort. Carbtune, Twinmax or home made http://www.airheads.org/content/view/183/98/ 3. Using your ears. No comprehensive articles that I could find.. In the spirit of learning to service and tune at home and after lots of reading, I decided that for me the "by ear" technique might be the most useful, as it doesn't require any special tools and can be performed anywhere. There is no risk of electrical damage to the bike or the one doing the adjusting. It was very difficult to find a comprehensive description of the procedure, so using the combi

On a Sure Footing....

I love my BMW. More than any other bike I have owned. This doesn’t mean that it is not without its blemishes. Take the hair trigger sidestand. Known to fold up when an Alpaca herder in the Andres sneezes and the bike is in Australia. Many a BMW owner has found their bike on its side on the ground. Fairing broken. The sidestand has folded up into the raised position. Why? Because it likes to. Once the smallest amount of weigh transfers off the side stand it will fly up. Also if you have an RT type fairing as mine does you can not put the stand down when sitting on the seat. Well I can’t with my short legs. I have to clamber off the bike while holding it up right and then use centre stand. I don’t trust the sidestand. This Video shows how vicious the original sidestand is. Click on the play button. That all changed yesterday. I fitted a SureFoot sidestand . Moto-Bins in the UK supply these. They are of a very sturdy construction. Comes with full fitting instructions and 2 new

Ride impression of the Yamaha MT-03.....

Yamaha have realeased their new 660 based single. The MT-03. See I so want one....MT-03 The bike can be had in Europe but not here in Aussie land. I have asked Yamaha Australia if they will bring them in. They said "No plans at this stage to introduce the MT03 in to Australia." To rub salt into the wounds, axxess , the forum admin guy at http://forum.monoconnection.nl/ got to ride one. NOOOO!!! So unfair. He translated his ride impression into English for those of us who will not get to ride this. Thank you mate for doing this for us. So lets see what he has to say..... Saturday 16 February I could try the Yamaha MT-03 at Gebben Motors. I could try a brand new red 2008 model. After a short instruction and a warning because of the new tires we were ready to go! The first thing I noticed was the enormous wide steer and the upright riding position It gave me a feeling of absolute control and power! The seat was quit hard but not uncomfortable at all. Unless it was still freez